Two years ago we dug and laid three conduits from the house to the garage, and from the garage to the shed. Primarily to get more power to the garage — and any power to the shed.

I used the opportunity to put in an additional conduit for fiber, and lots of conduits from the main switch board down into the basement.

I first got started on the network run from the attic switch to the 2nd floor den — back in October of 2021. I finished it a year later, so it’s about time to get this blog post published 😛

We recently moved the twins into their own bedrooms, after sharing a room for nine years — it was finally time for some privacy 🙂

With their own rooms; they also got their own computers — a life long dream 😉 Those computers needs network, proper network, not Wi-Fi.

We recently put up a wall in our previous family/play room — to make another bedroom, with a hallway outside. I might want an access point in that hallway at some point.

So I repurposed a telephone outlet and conduit, to run a CAT6 cable from the hallway down to the patch panel in the basement.

After my Wi-Fi mapping adventure — I found a few spots with low Wi-Fi signal. Both kids’ rooms on the 2nd floor only had mediocre signal, at -67 and -68 dBm 2.4 GHz, and the side garden had -71 dBm — which is terrible!

I also discovered that Mona’s side of the bed had much worse Wi-Fi signal than my side. This was because I had a clear line of sight to the UAP-AC-IW in the den, but the signal to Mona’s side had to go through a wall and her wardrobe…

Simply not acceptable, something had to be done!